Metrologic MS9530 Series Guia do Utilizador

MS9530 Series Voyager® RF Single Line Hand-Held RF Bar Code Scanner Installation and User’s Guide PRELIMINARY MS9530 Voyager RF

The system is ready to work. Please note again, that each time a Voyager RF is activated, it indicates its ID number just before linking with Base

BASE STATION TESTING BARCODE The Base Station will accept all data from Voyager RF where the Base Serial Number is “0000000000”. Use this Test Ba

BATTERY PACK In order to charge the Battery Pack, there is no need to use a cradle. It can be re-charged when disconnected from the scanner with th

Standby mode will discharge the battery pack in around 5 days. The number of readings will naturally decrease as the standby time increases. To avoi

VISUAL INDICATORS The scanner has RED and GREEN LED’s. When the scanner is on, these visual indicators show the state of the scanner functionality.

Low Battery Message When the battery starts to loose its charge, the scanner detects it and makes a Razzberry sound every time a new reading is p

PROGRAMING MODES Voyager RF can be programmed via Barcodes. Use Metrologic’s MetroSelect Single Line Configuration Guide to configure the unit. T

MetroSet It is possible to download/upload settings from MetroSet 2 (PC based software) to each Voyager RF by radio. In order to do that, read t

SOFTWARE VERSION It is possible to find out the software of Voyager RF as well as the Base Station to which the unit is linked with. Scanning the

EML EML Handshake is a defined data formatting handshake that allows the Voyager RF to send and receive data from the Host System through the Base

Table of Contents Voyager RF Scanner – Overview ... 3 Base Station...

MS9530 Voyager RF Printed: September 2002 Version: 1.1 Status: Approve

Product Overview The MS9530 Series Voyager RF is a wireless single line hand-held scanner with one bi-directi

BASE STATION The Base Station is a interface decoder to which the Voyager is connected via a virtual RS232 port. Its function is to receive RF da

UNPACKING LIST The kit is packed according to its functionality: Transmitter: • Voyager RF: Reader + Battery Pack • Wall-Power Supply for

CONNECTING THE BASE STATION TO THE HOST WEDGE INTERFACE 1. Turn off the Host system 2. Connect the cable Y-XX between the keyboard and Host 3

LINKING THE VOYAGER RF TO THE BASE STATION This section explains how to link the Voyager RF to the Base Station. It is supposed that the software

• Read Fix Serial RF Number barcode to load Base Station's serial number into the Voyager. • Read Base Station Serial Number barcode. (lo

FIXING VOYAGER RF ID NUMBERS This section explains how to fix an Identifier number to each Voyager RF. Basically, each Base Station can work with u