Metrologic MX003 Guia do Utilizador Página 1

MI8004/8008 HoloPlexer/Multiplexer Interface Box Installation and User’s Guide December 2007 00-02440

6CABLE CONNECTIONS AND CONNECTOR PIN OUTS (CONTINUED) Host Port (25-pin male d) pin out (unlisted pins are nc): 1 Shield (AC/.1uF) Earth Ground 2

7CABLING MASTER-SLAVE The HoloPlexer and the scanners connected to it support most of the options found in either the MetroSet

8SCANNER COMPATIBILITY Metrologic scanners can be input to HoloPlexer. There are some limitations for scanners other than HoloTrak as to the availa

9GETTING STARTED Make all the appropriate cable connections. Package detection/control output, host DTR and host RS-422 require internal jumper ch

10SUPPORTING PACKAGE DETECT/CONTROL OUTPUT Additional hardware is necessary when package detection/control output is desired from the HoloPlexer.

11SUPPORTING HOST DTR The Host’s DTR RS-232 control signal can be used as a hardware communication flow control signal controlling the HoloPlexer a

Copyright © 2007 by Metrologic Instruments, Inc. All rights reserved. No part of this work may b

WORLDWIDE HEADQUARTERS Metrologic Instruments, Inc. 90 Coles Rd. Blackwood, NJ 08012-4683 ▪ Email: [email protected] Customer Service Tel: 1-800-I

ii TABLE OF CONTENTS Introduction ...

1INTRODUCTION Metrologic’s HoloPlexer is a port and data concentrator used to simplify the installation of multiple scanners. The HoloPlexer is av

2LOCATING COMPONENTS Front Panel Component Location: 1. Host Transmit/Receive Communication Indicator (YELLOW) 2. Output Communication Connector

3HOLOPLEXER STATUS INDICATORS To enable the user to monitor HoloPlexer operation easily, different color status indicators (as indicated on the pre

4JUMPER SET UP The HoloPlexer contains three internal jumpers, which will require set up if any of the following features are to be used. 1. Host

5JUMPER SET UP (CONTINUED) 2. Use of MX006 or Other Accessories (J8): All accessories MUST be connected to the PORT-4/ACC connector of the HoloPle