Metrologic Fusion MS3780 Guia do Utilizador

MS3780 FusionOmni/Single Line Scanner ™ User’s Guide

6 INTRODUCTION Maintenance Smudges and dirt on the unit's window can interfere with the unit's performance. If the window requires clea

7 INSTALLATION RS232 or Light Pen 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin socke

8 INSTALLATION RS485 or OCIA 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the MVC cable into the 10-pin socket on the MS

9 INSTALLATION Keyboard Wedge 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin socket on th

10 INSTALLATION Stand-Alone Keyboard 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin sock

11 Figure 11. INSTALLATION Full Speed or Low Speed USB (Integrated) 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the USB Pow

12 INSTALLATION EAS Deactivation SW1 and SW2 are the switch banks inside the Checkpoint Device that set the deactivation range. The following is

13 SCANNER OPERATION The Scan Pattern Mode Select Button There are two configurable scan pattern modes available with the MS3780. • The primary

14 SCANNER OPERATION How to Use CodeGate and the Manual Activation Mode For illustration purposes the unit’s scan pattern has been set to single

15 SCANNER OPERATION Audible Indicators When the MS3780 is in operation, it can provide audible feedback. These sounds indicate the status of the

Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document

16 SCANNER OPERATION Visual Indicators There are four LEDs located on the top of the MS3780. When the scanner is on, the flashing or constant il

17 SCANNER OPERATION Failure Mode Indicators Both Blue LEDs Flashing with One Emitted Razzberry Tone This indicates that the scanner has experien

18 SCANNER OPERATION Depth of Field Specifications* Normal Scan Zone Specifications are based on a 0.33 mm (13 mil) bar code. Figure 19. Norm

19 SCANNER OPERATION Depth of Field Specifications* Reduced Scan Zone Specifications are based on a 0.33 mm (13 mil) bar code. Figure 20. Redu

20 SCANNER OPERATION Depth of Field by Bar Code Element Width* Normal Scan Zone MINIMUM BAR CODE ELEMENT WIDTH A B C D E F mm .13 .15

21 SCANNER OPERATION Depth of Field by Bar Code Element Width* Reduced Scan Zone MINIMUM BAR CODE ELEMENT WIDTH A B C D E F mm .13 .15

22 SCANNER OPERATION IR Activation Range* Fusion’s default power save mode† is Laser Off then Motor Off Delayed. This power save mode turns th

23 TROUBLESHOOTING GUIDE The following guide is for reference purposes only. Contact a Honeywell representative at to preserve the limited warran

24 TROUBLESHOOTING GUIDE Symptoms Possible Cause(s) Solution All Interfaces The unit scans a bar code, but locks up after the first scan (the whi

25 TROUBLESHOOTING GUIDE Symptoms Possible Cause(s) Solution All Interfaces During power up the unit beeps 3 times. There is a non-volatile RAM f

ii TABLE OF CONTENTS Introduction Product Overview ... 1

26 TROUBLESHOOTING GUIDE Symptoms Possible Cause(s) Solution RS232 Only The host is receiving data but the data does not look correct. The scanne

27 DESIGN SPECIFICATIONS MS3780 Operational Normal Depth of Field: 25 mm - 280 mm (1"- 11") 0.33 mm (13 mil) bar code Reduced Depth

28 DESIGN SPECIFICATIONS MS3780 Electrical Voltage Supply: 5VDC ± 0.25V Operating Power: 1.375 W Standby Power: 1.0 W Operating Current: 275

29 APPLICATIONS AND PROTOCOLS The model number on each scanner includes the scanner number and factory default communications protocol. SCANNER V

30 CONFIGURATION MODES The MS3780 Series scanner has three modes of configuration. • Bar Codes The MS3780 can be configured by scanning the bar c

31 UPGRADING THE FIRMWARE The MS3780 Fusion is part of Honeywell’s line of scanners with flash upgradeable firmware. The upgrade process requires

32 SCANNER AND CABLE TERMINATIONS Scanner Pinout Connections The MS3780 scanner interfaces terminate to a 10-pin modular socket. The serial numb

33 SCANNER AND CABLE TERMINATIONS Figure 25. MS3780-11 RS485  MS3780-9 OCIA Pin Function Pin Function 1 Ground 1 Ground 2 RS232 Transmit Outp

34 SCANNER AND CABLE TERMINATIONS Cable Connector Configurations (Host End) RS232 PowerLink Cable 53-53000x-3 Pin Function 1 Shield Ground 2

35 SCANNER AND CABLE TERMINATIONS Cable Connector Configurations (Host End) Keyboard Wedge PowerLink Cable 53-53002x-3 Pin Function 5-Pin DIN,

iii TABLE OF CONTENTS Troubleshooting Guide ... 23 Design Speci

36 REGULATORY COMPLIANCE Safety ITE Equipment IEC 60950-1 Second Edition, EN 60950-1 Second Edition Laser Laser Class 1: IEC 60825-1:Second Edit

37 REGULATORY COMPLIANCE Attenzione L’utilizzo di sistemi di controllo, di regolazioni o di procedimenti diversi da quelli descritti nel presente M

38 REGULATORY COMPLIANCE EMC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s author

39 LIMITED WARRANTY Honeywell International Inc. ("HII") warrants its products and optional accessories to be free from defects in mater

40 LIMITED WARRANTY All provisions of this Limited Warranty are separate and severable, which means that if any provision is held invalid and unen

41 INDEX A AC ... 2, 7–11 Accessories ... 2, 3 Adapter ...

42 INDEX M Maintenance ... 6 Manual... 2, 15, 29 Meteor ...

43 CUSTOMER SUPPORT Technical Assistance If you need assistance installing or troubleshooting your device, please contact us by using one of the

1 INTRODUCTION The MS3780 Fusion™ is a hand-held, omnidirectional bar code scanner with optional single-line scanning capabilities. It utilizes

Honeywell Scanning and Mobility 9680 Old Bailes Road Fort Mill, SC 29707 www.honeywellaidc.com 00-02269 Rev G 11/12

2 INTRODUCTION Scanner and Accessories BASIC KIT COMPONENTS Part No. Description MS3780 Fusion Scanner 00-02269 MS3780 User’s Guide * 00-02407

3 INTRODUCTION Scanner and Accessories OPTIONAL ACCESSORIES Part No. Description MVC-3MNC-N7052 Voltage Converter Cable, ±12VDC to +5.2VDC For OC

4 INTRODUCTION Scanner Components Figure 1. Scanner Components ITEM NO. DESCRIPTION 1 Red Output Window, Laser Aperture (See page 36) 2 Mode Se

5INTRODUCTION Caution and Serial Number Labels Figure 2. Caution and Serial Labels Caution: To maintain compliance with applicable stan