Metrologic TECH 10 Especificações

METROLOGIC INSTRUMENTS, INC. TECH 10® LASER BAR CODE PROJECTION SCANNER (1070) INSTALLATION AND USER’S GUIDE

Figure 2 6

LABELS A label is inside the window of the scanner noting that this device is a CDRH Class IIA laser product and IEC 825 LASERKLASSE 1. Also, on the

MAINTENANCE Smudges or dirt that appears on the scanner window can interfere with proper scanning. Therefore, only maintenance required is an occasio

APPENDIX A Specifications Application: Universal Industrial Scanner Light Source: Visible Laser Diode 650 ± 5nm Laser Class: CDRH: CLASS IIa; EN

APPENDIX A (CONTINUED) Operational Depth of Scan Field: 254 mm to 559 mm (10" to 22") Scan Speed: 1,250 scan lines per second Scan Patte

APPENDIX B Pin Assignments for the Mil spec Connector Each TECH 10®scanner has a 19-pin male Mil spec connector that is on the side of the unit. To

12 APPENDIX C Limited Warranty The Tech 10® scanners are manufactured by Metrologic at its Blackwood, New Jersey, U.S.A. facility Tech 10®. The

APPENDIX D Notice This equipment has been tested and found to comply with limits for a Class A digital device, pursuant to part 15 of the FCC Rules.

14 APPENDIX D (CONTINUED) EUROPEAN STANDARD Warning This is a class A product. In a domestic environment this product may cause radio interf

15Appendix E Patents For patent information, please refer to www.honeywellaidc.com/patents.

16 Index A AC 2, 9 Application 9 Asia ii ASIC 1 Assignments pin 11 B Bar code(s) 1, 3, 4, 7 Beep 3 Beeper operation 10 C Cable

17RMA 12 Roll, pitch, yaw 10 RS-232 10, 11 S Scan field 10 Scan lines 10 Scan pattern 10 Scan speed 10 ScanSelect 1, 3 ScanSet 3 Service 12

LOCATIONS CORPORATE HEADQUARTERS North America Metrologic Instruments, Inc. Customer Service: 1-800-ID-METRO 90 Coles Road Tel: 856-228-8100

TABLE OF CONTENTS Introduction ...

INTRODUCTION Metrologic's TECH 10® laser bar code projection scanner is encased in a NEMA-12 steel case. The scanner's construction enable

SCANNER CONNECTIONS TO THE HOST To avoid potential problems, do not power up the scanner until the communication cable is secured to the host 1.

CONFIGURATION OF THE SCANNER TO THE HOST SYSTEM The scanner is shipped from the factory programmed to a set of default conditions noted in the ScanSe

PARTS OF THE SCANNER Becoming familiar with the features of the TECH 10® scanner will help when operating the scanner. The following illustration and

INSTALLATION OF THE STAND With the Metrologic stand (Part #45-45479), the scanner can be positioned in a vertical orientation. To use this stand, fo