Metrologic TECH 7 Manual do Utilizador descarregar pdf (Página 107)

Prefixes/Suffixes

SECTION E CHARACTER REPLACEMENTS

To replace a character:

1. Scan the Enter/Exit Configuration Mode bar code

(located on page x, at the front of this guide)

2. Scan the Character to Replace Code (shown below)

3. Scan the ASCII Code Byte value of the character you with to replace.

(refer to the ASCII reference table in Section M)

4. Scan the Replacement Character bar code

5. Scan the ASCII Code Byte value of the replacement character.

6. Scan the Enter/Exit Configuration Mode bar code.

(located on page x, at the front of this guide)

Character to Replace No Replacement

³938600 ³838600

Replacement Character

³938700

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 187 188

Sem comentários

Metrologic TECH 7 Manual do Utilizador Página 107